Connect the input and output jack tip lugs to their appropriate spots on the switch — input to lug 9 and output to lug 8 .
Solder the resistor to the LED ’ s positive lug , and then attach the other end of the resistor to one of the power lugs on the DC jack . DO NOT solder yet .
Your pot has a metal tab on it that prohibits it from being mounted properly . Remove it with pliers and insert the pot and board . Attach the loose wires to their destinations , including the power ( thread power wire through both positive lugs , one of which is shared with the LED resistor and solder them both ), ground ( attach to previously unsoldered ground lug ), Gain 3 wire ( to any ground point ) and circuit inputs and outputs ( lugs 5 and 7 , respectively ).
STEP 7 : You ’ re done !
STEP 4 :
Connect the input and output jack tip lugs to their appropriate spots on the switch — input to lug 9 and output to lug 8 .
STEP 5 :
Solder the resistor to the LED ’ s positive lug , and then attach the other end of the resistor to one of the power lugs on the DC jack . DO NOT solder yet .
STEP 6 :
Your pot has a metal tab on it that prohibits it from being mounted properly . Remove it with pliers and insert the pot and board . Attach the loose wires to their destinations , including the power ( thread power wire through both positive lugs , one of which is shared with the LED resistor and solder them both ), ground ( attach to previously unsoldered ground lug ), Gain 3 wire ( to any ground point ) and circuit inputs and outputs ( lugs 5 and 7 , respectively ).
STEP 7 : You ’ re done !
46 DIY // Build Your Own Jack Orman MOSFET Booster