OK? NOW LET'S BUILD THE ENCLOSURE!
YOU'LL NEED:
• 1x enclosure drilled for two
footswitches, two ¼” jacks, one
DC jack, two LEDs, four knobs and one
toggle. I used 125B size because it
makes mounting the board to
the inside much easier.
• 2x 3PDT latching
(not momentary) footswitches
• 2x ¼” mono jacks
• 2x LED
• 2x LED bezel (same size as LEDs)
• 1x DC power jack
• 4x knobs of your choosing
(three of one color and one of
a separate color, if desired)
• 2x 4.7k resistors (for LEDs)
Build notes: A dual footswitch wiring
is much like our previous builds, except
the grounding is a bit different and
there’s an extra step at the end
linking the two switches.
LET’S
GET
THIS
THING
DONE!
46
TONE TALK //
DIY: Double Whammy: Build The Tim Escobedo Square Wave Shaper and Idiot Wah