STEP 1:
Insert resistors and diodes into board.
Bend the leads, solder them in, and clip
off the excess. Save these leads for the
next step
STEP 2:
Use these leads to form the jumper
wires as shown. One of the jumpers is
long enough to where you may need to
use a piece of stripped wire. Bend them
outward and clip them off. Save two extra
leads from Step 1, discard the rest.
STEP 3:
Insert the trimpot and sockets. Using a
flat object, turn the board over, holding
it in place so the sockets don’t fall out.
You may need to put a piece of insulator
between the trimpot’s legs and the
jumper wire underneath.
44
TONE TALK //
DIY: Double Whammy: Build The Tim Escobedo Square Wave Shaper and Idiot Wah