Glue the resin cabochon with e-6000 to the
center of the heart pendant. Fold the prongs
over the resin cabochon.
Form the two wire heart shapes by marking
the center of each 5” piece of 12 g. square
wire. Use your beading pliers on the mark
and force the wire into a sharp bend. Use
your ring bender pliers or a 3/4” dowel to
shape the top curve of your heart. Use your
file to shape the wire where it meets at the
top so that there is no gap. Glue this join with
e-6000 glue. It may be necessary to tape this
while it dries.
The third piece of wire is used to join the pendant to the necklace. Mark the center of the
wire. Hold your pliers on the mark and bend
each arm upwards. Now slide the wire into
the pendant bail so the center mark is inside
the bail. Now use your ring pliers or dowel to
form the upper curves of your heart shape.
Now use your beading pliers to form a loop on
each arm that goes to the i